Now that the seams are reinforced from the inside, I can remove the tape from the outside of the lute body, and clean up each rib where it meets its neighbor.

Once again, a simple wood scraper should do the trick.

Thereafter, I must shape and install the end clasp – and then….but that is enough for now.

As Dad used to say about boat-building: one job at a time, bit by bit, and all things in due succession….

4 thoughts on “LEARNING CURVE 11”

  1. Very beautiful! I was thinking that if you collected all these updates and pictures together, at the end of it all, there is a book, ready-made . . .

Leave a Reply

Your email address will not be published.